Wansview B Series Manual de usuario descargar pdf (Pagina 11)

H Series IP Camera User Manual - Waterproof

5.2.5 Record

Click “Record” button, which could record the video with audio and store it at the present path.

When recording, there will be an indicated symbol in the status of video display area to show

you it is recording. Click the “Record” button again, and then the record stops.

5.2.6 Playback

Click “Playback” button, it will pop up a player which could play the video stored on your PC

disk.

Figure 10

, these buttons are for play, stop, the previous recorder, the next

recorder, open the recorder file. Please click the button of “open the recorder file” first,

and select the file you want to play, you can playback the recorder.

5.2.7 The control of Pan/Tilt

For the control of PTZ, 485 interface of the equipment must be connected with the PTZ

decoder. Please refer to the7.4.6 part for configuration and make sure the

communication between equipment and PTZ decoder goes well.

In the PTZ control area, the user can control PTZ by click the arrow rotation direction (up,

down, left, right). If the PTZ adopts the pelco-p protocol, click

, it can realize

automatic cruise, click

, it will stop automatic cruise. If the PTZ use other protocols,

it does not support the auto-cruise and stop cruising.

User can click

button when PTZ move to a desired location. When the control of

PTZ rotate to another location, just click on

button, the PTZ will be moved

immediately back to the pre-set position.

Note:

and are used for zoom, only used in some model.

5.3 Notice (for the first time use)

Please change the following 2 settings when using for the first time:

1) Please refer to the content of part 7.4.1 to change the initial passwords of admin, user,

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Sin comentarios

Wansview B Series Manual de usuario Pagina 11