Wansview B Series Manual de usuario descargar pdf (Pagina 7)

H Series IP Camera User Manual - Waterproof

4.2 Visit Instruction

To visit the IP Camera, you should do some settings of IP Camera and Internet besides

getting the communication link fluency.

1) The PC and IP Camera are in the same LAN. If you want to use this PC to visit the IP

Camera, you need to make sure their IP address is at the same segment. Otherwise you

need to do the reset of the IP Camera’s IP address. For example, the IP Camera-1’s IP

address in Figure 3 is 192.168.1.139 (at the segment of 192.168.1), while the PC-1’s IP

address is 192.168.0.175 (at the segment of 192.168.0), then you will be not able to visit

the IP Camera through the PC-1. You need to change the IP Camera-1’s IP address to

192.168.0.139 firstly.

2) The PC and IP Camera are in different LANs, but they are all connected to Internet. For

the IP Camera-1 and PC-2 in Figure 3, if you want to visit IP Camera-1 by PC-2, you

should firstly do the setting as 1) to make sure that you can visit IP Camera-1 through

PC-1 and then do the setting of router-1 (do the port forwarding from the router). The

PC-2’s visit

application could be sent through router-1 to IP Camera-1. Normally, PC-2

could only send the information to router-1, if you don’t do the setting of router-1, then

PC-2 could not visit IP Camera-1.

5 Visit IP Camera from LAN

5.1 Set IP Address

The IP addresses of IP Camera and PC should be at the same segment, in Figure 3, the IP

Camera-1 can’t be visited. Run the HSearch_en.exe in the CD, click Search button, and then

select the IP Camera to reset the IP Camera’s IP address, as the Figure 4.

Setting Instruction:

9 Please carefully check the “Local PC information” on the top left corner which lists the

PC configuration. If there are several network adapters in the PC, please select the one

you are using and make sure the IP address of IP Camera is as the same segment of

the PC.

9 Change the content of “IP config” on the right to make sure the content is the same as

“Local PC information”. Only the last section of the IP address which needs setting by

yourself, you can set it as 139 just like Figure 4.

9 If you don’t know how to fill out the content of “IP config”, you could also tick the “Set IP

automatically” to get the IP address from the router automatically (If can’t get IP from

router, the IP Camera will set it to 192.168.0.158 for itself).

9 Put the user name and password into “Authentication” (By default, the user name is:

admin, password is: 123456). Click “Update”. The setting will take effect now. Select

the device in list box, click “Browse” button, it will open the Browser automatically and

pop up a window at the same time which requires to inputting the user name and

password. Then you see the home page of the IP Camera-1, just as below Figure 5.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Sin comentarios

Wansview B Series Manual de usuario Pagina 7