Wansview B Series Manual de usuario descargar pdf (Pagina 12)

H Series IP Camera User Manual - Waterproof

and guest. Their initial passwords are respectively “123456”, “user”, “guest”.

2) Refer to the content of part 7.5.1 to set the system time.

6 Visit IP Camera from WAN

6.1 Port forwarding

Follow the “Visit IP Camera from LAN” steps; make sure PC-1 can visit IP Camera-1. In

Figure 3, before the computers in WAN (PC-2, PC-3) can visit the IP Camera-1, must put

the IP Camera -1 into WAN. You can set port forwarding on Router-1 to put IP Camera-1 into

WAN.

Open the Router Setting interface on PC-1. The interfaces for different routers are different,

and the port forwarding settings are different, please refer the router manual to set. For most

routers, “Virtual server” option can be found in setting interface. Fill the IP address and port of

IP Camera-1 into corresponding blank. Figure 11 is an example.

Figure 11

Select “status” option and remember the WAN IP address, enter the IP address in browser of

PC-1, if IP Camra-1 can be visited via PC-1, the port forwarding is success. And PC-2 and

PC-3 can also visit the IP Camera-1.

WAN IP address is allotted by ISP, please make sure it’s an available WAN IP

address. As WAN IP address is lack, many WAN IP address are available in limited

area. If PC-2 and PC-3 are not in this area, the IP Camera-1 won’t be visited by

them.

If user wants to put several IP Cameras into WAN, every device should set the port

forwarding. In order to distinguish these devices, every device should set a

different port. If the port of the device is not 80, should add the port to IP address

with colon to visit the IP Camera. Example: http://202.96.82.177:81

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Sin comentarios

Wansview B Series Manual de usuario Pagina 12